|
|
Int. Dia. |
80 |
100 |
125 |
150 |
|
Ext.Dia. |
125 |
150 |
180 |
200 |
|
Installed Lengths |
|
B Max. |
510 |
510 |
510 |
510 |
|
B Min. |
345 |
345 |
345 |
345 |
This component is designed to provide onsite adjustment and is used where accurate linear movements are required. This is a non load bearing telescopic pipe and at its full extension must have a telescopic overlap of at least 50mm. A wall support must be used on the component directly above the adjustable length to support the chimney run. Four by equidistant hole must be drilled on the telescopic body to allow for fitting 5mm stainless steel rivets. |